Service Work: Steering Gear Box Parts Replaced & Repaired Cylinder Head Replaced and Milled Head gasket Kit 12 Volt Alternator Conversion Kit New 12 Volt Battery Valve parts replaced New Fuel Tank, Front spindle bushings, Front stay rods, Front axle pivot bushing, front axle pivot pin

Ford 9N Tractor

Service work Date: May, 2008

Serviced by: Owosso Tractor Parts

www.owossotractorparts.com

1-888-530-4554

New, Used & Rebuilt Tractor Parts. Tractor Repair

Alternator Conversion Kit to 12 Volt. Includes: Uni-charge Alternator Alternator pulley Wiring Harness Necessary brackets Alternator belt Ballast Resistor 12 Volt Coil on early tractors only. Not included in the kit: 60 Amp gage. 12 volt Battery: 525 cca seems to work well with the starter.	12 Volt Coil. You do not need to change the points, condenser or rotor, unless they are bad. Even though you change the coil to 12 volt, you still need to add the ballast resistor.	The alternator conversion kit for the 2n, 9n, and early 8n and late model 8n tractors are a real improvement on turning the engine over and starting. Remember, when replacing the battery to only use a battery with about 525 cca. Any bigger and it can destroy the starter drive or the starter. Be sure to change the battery cables to a Negative ground with the 12 volt system. On late model 8n conversion kits be sure to reverse the wires on the coil so the + is your hot wire and the – goes to the distributor	Look at the rear exhaust valve. When we pulled the cylinder head off this engine to replace the head gasket, this valve was loose. The keeper and valve guide clip were lying in the valve spring area.
Ford 9N. This tractor is actually a very nice tractor even though it needed a lot of work; mechanically it was tight and runs very well.	See how black this head gasket is. I don’t think there was any area of this gasket that was good. Black exhaust between the cylinders indicates a blown head gasket.	This is a fresh milled cylinder head. It was warped about .010”. Way too much for these or any motor. The head was magged for cracks before it was milled. Be sure to re-torque the head nuts/bolts after running the engine for a few minutes. They always retighten on these motors after running.	We use Hi-Tach made by Permatex on the cylinder head and the cylinder block. When using Hi-tach be sure not to lift the head gasket after contact. It will actually take the gasket material off the gasket
New head gasket in place.	New steering side gears are common on the 9N and 2N tractors.	Reconditioned head bolted in place. Oil change, Alternator kit, Steering Gears replaced, New 12 Volt Battery.	Back Together
We overhaul tractor motors Clutch work Tune Ups Brake service And a lot more.	We repair most makes & models.	Complete tractor service at our shop	Oops! Where’s the hood? Ah, who needs one? Get’s better gas mileage without it and it’s aerodynamic. Could use a steering wheel or at least a pair if vise-grips to hold on to.

A free service page compliments of:
Owosso Tractor Parts
6990 W. M21
Owosso, MI 48867
1-888-530-4554 Toll free
1-989-729-6567 Local
www.owossotractorparts.com
sales@owossotractorparts.com
bobscorner@owossotractorparts.com